Startup process, Configuration fundamentals – H3C Technologies H3C MSR 20-1X User Manual
Page 39
32
3.
After the power-on self-test (POST), the system prompts you to press Enter. When a command line
prompt appears, you can proceed to configure the router.
Startup Process
After power-on or during the reboot process, the following information is displayed on the terminal:
System application is starting...
Booting Normal Extend BootWare...
**************************************************************************
* *
* MSR20-12 BootWare, Version 2.02 *
* *
**************************************************************************
Compiled Date : Jul 29 2008
CPU Type : MPC8323E
CPU L1 Cache : 16KB
CPU Clock Speed : 333MHz
Memory Type : DDR SDRAM
Memory Size : 256MB
Memory Speed : 132MHz
BootWare Size : 1024KB
CPLD Version : 1.0
PCB Version : 3.0
BootWare Validating...
Press Ctrl+B to enter extended boot menu....
Press Ctrl + B to enter the extended Boot ROM menu. Otherwise, the system goes into the program
decompression process.
NOTE:
Press Ctrl+B within six seconds after “Press Ctrl+B to enter extended boot menu...” appears to enter the
extended Boot ROM menu. Otherwise, the system goes into the program decompression process. You
need to restart the router if you want to enter the extended Boot ROM menu after the decompression
process.
Starting to get the main application file--flash:/main.bin!.................
..........................................................................
........
The main application file is self-decompressing
Press Enter. The router enters user view and you can configure the router.
Configuration Fundamentals
In general, the router configuration steps are as follows: