Configuring ethernet interface parameters – H3C Technologies H3C MSR 20-1X User Manual
Page 55
48
Configuring Ethernet Interface Parameters
Before upgrading an application program through an Ethernet interface, we need to configure the
Ethernet interface on the router as follows:
Enter 3 in the BootWare menu to enter the Ethernet interface submenu. Then, enter 5 to enter the change
Ethernet parameter submenu:
=========================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
==========================================================================
Protocol (FTP or TFTP) :tftp ftp
Load File Name :host
:
Target File Name :target
:
Server IP Address :192.168.1.1
Local IP Address :192.168.1.253
Gateway IP Address :0.0.0.0
FTP User Name :user
FTP User Password :password
Table 24 Ethernet parameters settings description
Parameter Description
'.' = Clear field
To clear the current field, input a (.) and then press Enter.
'-' = Go to previous field
To go to the previous field, input a hyphen (-) and then press Enter.
Ctrl+D = Quit
The shortcut key combination for exiting the parameter configuration
page is Ctrl+D.
Protocol (FTP or TFTP)
Select a transmission protocol, FTP or TFTP.
Load File Name
Name of the source file, which must be consistent with the actual name
of the file to be downloaded.
Target File Name
Name for the target file to be saved. By default, it is the same as the
name of the source file on the server.
Server IP Address
IP address of the FTP/TFTP server. To set a mask, separate the IP
address from the mask with a colon (:), for example,
192.168.80.10:24.
Local IP Address
IP address of the local end, that is, the IP address of the FTP/TFTP
client.
Gateway IP Address
Configure the gateway IP address if the server and the client are not
on the same network segment.
FTP User Name
This option is not available for TFTP.
FTP User Password
This option is not available for TFTP.