Verifying the installation, Powering on the router – H3C Technologies H3C MSR 2600 User Manual
Page 43
36
Figure 46 Connecting an AC power cord to an MSR 26-30 router
NOTE:
The power cords in the figures are for illustration only.
Verifying the installation
After you complete the installation, verify that:
•
There is enough space around the router for heat dissipation.
•
The router is mounted securely in a rack, on a sturdy workbench, or on a wall.
•
Antennas, USB devices, and interface modules are installed correctly.
•
The router, rack, and power module are grounded correctly.
•
The correct power source is used.
•
The router is connected correctly to the console terminal and other devices. Parameters are
configured correctly on the console terminal.
Before starting up the router, set up the console terminal as described in "
Then, power on the router and perform initial configuration for the router.
Powering on the router
WARNING!
Before powering on the router, locate the power source switch so that you can cut off power promptly in
case of an emergency.
1.
Switch on the power source.
2.
Turn on the power switch on the router.