H3C Technologies H3C MSR 2600 - Manual (Page 34)

27
Installing an interface module
Installing a SIC
CAUTION:
SICs are not hot swappable. Make sure the router is powered off before installing a SIC.
Do not install a SIC on an MSR 26-00-5 router.
To install a SIC:
1. Remove the fastening screws with a Phillips screwdriver to remove the blank filler panel.
Keep the removed blank filler panel for future use.
Figure 28 Removing the blank filler panel
2. Push the SIC slowly along the slide rails into the slot until it makes close contact with the backplane
of the router.
Figure 29 Installing the SIC
3. Use a Phillips screwdriver to fasten the captive screws on the SIC.
Installing a DSIC
CAUTION:
DSICs are not hot swappable. Make sure the router is powered off before installing a DSIC.