H3C Technologies H3C MSR 2600 - Manual (Page 35)

28
You can only install DSICs on an MSR 26-30 router.
To install a DSIC:
1. Remove the screws on the blank filler panels in slot 1 and slot 2 of the router to remove the blank
filler panels.
Figure 30 Removing the blank filler panels
2. Loosen the captive screws on the slot divider and pull out the slot divider.
Figure 31 Removing the slot divider
3. Insert the DSIC into the slot and push it along the slide rails until it makes close contact with the
backplane of the router.
Figure 32 Installing a DSIC
4. Fasten the captive screws to secure the DSIC.