H3C Technologies H3C MSR 2600 - Manual (Page 24)

17
2. Wear the insulation covering on the grounding cable as shown in Figure 12 . Insert the bare metal
part of the grounding cable to the end of the ring terminal.
3. Use the needle-nose pliers to secure the metal part of the cable to the ring terminal end.
4. Cover the joint with the insulation covering.
5. User the blower dryer to dry the insulation covering.
6. Make sure the insulation covering fully covers the joint.
Figure 12 Attaching the ring terminal
Grounding the router through the rack
IMPORTANT:
Make sure the rack is correctly grounded before grounding the router.
To connect the grounding cable:
1. Remove the grounding screw from the rear panel of the chassis.
2. Use the grounding screw to attach the ring terminal of the grounding cable to the router.
See
Figure 13 .