beautypg.com

Verifying the configuration – H3C Technologies H3C MSR 50 User Manual

Page 42

background image

34

[RouterA-Ethernet1/1] vrrp vrid 1 authentication-mode simple hello

# Configure the master to send VRRP packets at an interval of five seconds.

[RouterA-Ethernet1/1] vrrp vrid 1 timer advertise 5

# Configure Router A to operate in preemptive mode, and set the preemption delay to five

seconds.

[RouterA-Ethernet1/1] vrrp vrid 1 preempt-mode timer delay 5

# Configure to monitor track entry 1 and specify the priority decrement to 30.

[RouterA-Ethernet1/1] vrrp vrid 1 track 1 reduced 30

5.

Configure VRRP on Router B:

system-view

[RouterB] interface ethernet 1/1

# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.

[RouterB-Ethernet1/1] vrrp vrid 1 virtual-ip 10.1.1.10

# Set the authentication mode of VRRP group 1 to simple, and the authentication key to hello.

[RouterB-Ethernet1/1] vrrp vrid 1 authentication-mode simple hello

# Configure the master to send VRRP packets at an interval of five seconds.

[RouterB-Ethernet1/1] vrrp vrid 1 timer advertise 5

# Configure Router B to operate in preemptive mode, and set the preemption delay to five

seconds.

[RouterB-Ethernet1/1] vrrp vrid 1 preempt-mode timer delay 5

Verifying the configuration

After configuration, ping Host B on Host A, and you can see that Host B is reachable. To view the

configuration result, use the display vrrp command.
# Display detailed information about VRRP group 1 on Router A.

[RouterA-Ethernet1/1] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Ethernet1/1

VRID : 1 Adver Timer : 5

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : Simple Key : ******

Virtual IP : 10.1.1.10

Virtual MAC : 0000-5e00-0101

Master IP : 10.1.1.1

VRRP Track Information:

Track Object : 1 State : Positive Pri Reduced : 30

# Display detailed information about VRRP group 1 on Router B.

[RouterB-Ethernet1/1] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

This manual is related to the following products: