beautypg.com

High availability technologies, Fault detection technologies, Protection switchover technologies – H3C Technologies H3C MSR 50 User Manual

Page 10

background image

2

MTTR = fault detection time + hardware replacement time + system initialization time + link recovery time

+ routing time + forwarding recovery time. A smaller value of each item means a smaller MTTR and a
higher availability.

High availability technologies

Increasing MTBF or decreasing MTTR can enhance the availability of a network. The high availability

technologies described in this section meet the level 2 and level 3 high availability requirements in the
aspect of decreasing MTTR.
High availability technologies can be classified as fault detection technologies or protection switchover

technologies.

Fault detection technologies

Fault detection technologies enable detection and diagnosis of network faults:

BFD is a generic fault detection technology that can be used at any layer.

NQA is used for diagnosis and evaluation of network quality.

Track works along with other high availability technologies to detect faults through a collaboration
mechanism.

Table 2 Fault detection technologies

Technology Introduction

Reference

BFD

BFD provides a single mechanism to quickly detect and monitor the
connectivity of links or IP forwarding in networks. To improve network

performance, devices must quickly detect communication failures to

restore communication through backup paths as soon as possible.

"Configuring BFD"

NQA

NQA analyzes network performance, services and service quality
through sending test packets, and provides you with network

performance and service quality parameters such as jitter, TCP

connection delay, FTP connection delay and file transfer rate.

Network
Management and

Monitoring
Configuration

Guide

Track

The Track module implements collaboration between different
modules. The collaboration involves three sets of modules:

application, Track, and detection. These modules collaborate with
one another through collaboration entries. The detection modules

trigger the application modules to perform certain operations through

the Track module. The detection modules probe such items as link
status and network performance, and inform the application modules

of the detection result through the Track module. Once notified of

network status changes, the application modules use the changes to
avoid communication interruption and network performance

degradation.

"Configuring
Track"

Protection switchover technologies

Protection switchover technologies aim at recovering network faults. They back up hardware, link, routing,

and service information for switchover in case of network faults to ensure continuity of network services.

This manual is related to the following products: