Configuration procedure – H3C Technologies H3C MSR 50 User Manual

Page 27

Configure the available bandwidth used for setting the thresholds and the enable-threshold and

disable-threshold of load balancing.

Figure 8 Network diagram

Configuration procedure

Configure IP addresses:
Follow

to configure the IP address and subnet mask for each interface. (Details not

shown.)

Configure a static route:
# On Router A, configure a static route to the segment 192.168.2.0/24 where Host B resides.

system-view

[RouterA] ip route-static 192.168.2.0 24 serial 2/0

[RouterA] ip route-static 192.168.2.0 24 serial 2/1

[RouterA] ip route-static 192.168.2.0 24 serial 2/2

# On Router B, configure a static route to the segment 192.168.1.0/24 where Host A resides.

system-view

[RouterB] ip route-static 192.168.1.0 24 serial 2/0

[RouterB] ip route-static 192.168.1.0 24 serial 2/1

[RouterB] ip route-static 192.168.1.0 24 serial 2/2

Disable the fast forwarding function:
# Disable the fast forwarding function on interfaces Serial 2/0, Serial 2/2, and Serial 2/2 on
Router A.

[RouterA] interface serial 2/0

[RouterA-Serial2/0] undo ip fast-forwarding

[RouterA-Serial2/0] quit

[RouterA] interface serial 2/1

[RouterA-Serial2/1] undo ip fast-forwarding

[RouterA-Serial2/1] quit

[RouterA] interface serial 2/2

[RouterA-Serial2/2] undo ip fast-forwarding

[RouterA-Serial2/2] quit

# Disable the fast forwarding function on interfaces Serial 2/0, Serial 2/2, and Serial 2/2 on

Router B.

[RouterB] interface serial 2/0

[RouterB-Serial2/0] undo ip fast-forwarding

This manual is related to the following products: