H3C Technologies H3C MSR 50 - Manual (Page 34)

26
NOTE:
•
When associating Track with BFD, do not configure the virtual IP address of a VRRP group as the local
or remote address of a BFD session.
• The remote and local addresses in the track bfd echo command indicate the next hop and destination
address of BFD echo packets, respectively.
Associating Track with interface management
The interface management module monitors the physical status or network-layer protocol status of the
interface. The interface management module functions as follows when it is associated with a track entry:
• When the physical or network-layer protocol status of the interface changes to up, the interface
management module informs the Track module of the change and the Track module sets the track
entry to Positive.
• When the physical or network-layer protocol status of the interface changes to down, the interface
management module informs the Track module of the change and the Track module sets the track
entry to Negative.
To associate Track with interface management:
Step Command Remarks
32. Enter system view. system-view N/A
33. Associating Track with
interface management.
• Create a track entry, associate it with
the interface management module to
monitor the physical status of an
interface, and specify the delay time for
the Track module to notify the
associated application module when
the track entry status changes:
track track-entry-number interface
interface-type interface-number [ delay
{ negative negative-time | positive
positive-time } * ]
• Create a track entry, associate it with
the interface management module to
monitor the Layer 3 protocol status of
an interface, and specify the delay time
for the Track module to notify the
associated application module when
the track entry status changes:
track track-entry-number interface
interface-type interface-number
protocol { ipv4 | ipv6 } [ delay
{ negative negative-time | positive
positive-time } * ]
Use either method.
No track entry is created by
default.