beautypg.com

Displaying and maintaining interface backup, Interface backup configuration examples, Network requirements – H3C Technologies H3C MSR 50 User Manual

Page 25: Configuration procedure, Multi-interface backup configuration example

background image

17

Step Command

Remarks

26.

Set the delay timer for the
backup function to take

effect on system startup.

standby timer startup seconds

Optional.
30 seconds by default.

Displaying and maintaining interface backup

Task Command

Remarks

Display statistics about the traffic
on the active interfaces enabled

with load balancing.

display standby flow [ | { begin | exclude
| include } regular-expression ]

Available in any view.

Display the state information of the
active and standby interfaces.

display standby state [ | { begin | exclude
| include } regular-expression ]

Available in any view.

Interface backup configuration examples

Multi-interface backup configuration example

Network requirements

Use interfaces Serial 2/1 and Serial 2/2 on Router A to back up the active interface Serial 2/0,
assigning interface Serial 2/1 a higher priority, and configure switchover delays.

Figure 7 Network diagram

Configuration procedure

1.

Configure IP addresses:
Follow

Figure 7

to configure the IP address and subnet mask for each interface. (Details not

shown.)

2.

Configure a static route:
# On Router A, configure a static route to the segment 192.168.2.0/24 where Host B resides.

system-view

[RouterA] ip route-static 192.168.2.0 24 serial 2/0

This manual is related to the following products: