H3C Technologies H3C MSR 50 - Manual (Page 118)

110
# Display the detailed information about VRRP group 1 on Router C.
[RouterC-Ethernet1/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Load Balance
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface Ethernet1/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 5
Become Master : 4200ms left
Auth Type : None
Virtual IP : FE80::10
1::10
Member IP List : FE80::3 (Local, Backup)
FE80::1 (Master)
FE80::2 (Backup)
Forwarder Information: 3 Forwarders 1 Active
Config Weight : 255
Running Weight : 255
Forwarder 01
State : Listening
Virtual MAC : 000f-e2ff-4011 (Learnt)
Owner ID : 0000-5e01-1101
Priority : 127
Active : FE80::1
Forwarder 02
State : Listening
Virtual MAC : 000f-e2ff-4012 (Learnt)
Owner ID : 0000-5e01-1103
Priority : 127
Active : FE80::2
Forwarder 03
State : Active
Virtual MAC : 000f-e2ff-4013 (Owner)
Owner ID : 0000-5e01-1105
Priority : 255
Active : local
Forwarder Weight Track Information:
Track Object : 1 State : Positive Weight Reduced : 250
The output shows that in VRRP group 1, Router A is the master and Router B and Router C are the
backups. Each router has one AVF and two LVFs that act as the backups.
# When Ethernet 1/2 on Router A fails, use the display vrrp ipv6 verbose command to display the
detailed information about VRRP group 1 on Router A.
[RouterA-Ethernet1/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Load Balance