H3C Technologies H3C S7500E Series Switches - Manual (Page 168)

15-11
To do… Use the command… Remarks
Enter tunnel interface view interface tunnel number —
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
Configure a
global unicast
IPv6 address or
a site-local
address
ipv6 address
ipv6-address/prefix-length eui-64
Required
Use either command.
By default, no IPv6 global unicast
address or site-local address is
configured for the tunnel interface.
ipv6 address auto link-local
Configure an
IPv6 address
for the tunnel
interface
Configure a
link-local IPv6
address
ipv6 address ipv6-address
link-local
Optional
By default, a link-local address will
automatically be created when an
IPv6 global unicast address or
site-local address is configured.
Specify the IPv6 manual tunnel
mode
tunnel-protocol ipv6-ipv4
Required
By default, the tunnel is a GRE over
IPv4 tunnel. The same tunnel mode
should be configured at both ends
of the tunnel. Otherwise, packet
delivery will fail.
Configure a source address or
interface for the tunnel
source { ip-address |
interface-type interface-number }
Required
By default, no source address or
interface is configured for the
tunnel.
Configure a destination address
for the tunnel
destination ip-address
Required
By default, no destination address is
configured for the tunnel.