H3C Technologies H3C S7500E Series Switches - Manual (Page 108)

10-7
Figure 10-6 Add a mapping between domain name and IPv6 address
2) Configure the DNS client
# Enable dynamic domain name resolution.
system-view
[Switch] dns resolve
# Specify the DNS server 2::2.
[Switch] dns server ipv6 2::2
# Configure com as the DNS suffix.
[Switch] dns domain com
3) Configuration verification
# Use the ping ipv6 host command on the Switch to verify that the communication between the
Switch and the host is normal and that the corresponding destination IP address is 1::1.
[Switch] ping ipv6 host
Trying DNS resolve, press CTRL_C to break
Trying DNS server (2::2)
PING host.com (1::1):
56 data bytes, press CTRL_C to break
Reply from 1::1
bytes=56 Sequence=1 hop limit=126 time = 2 ms
Reply from 1::1
bytes=56 Sequence=2 hop limit=126 time = 1 ms
Reply from 1::1