H3C Technologies H3C S9800 Series Switches - Manual (Page 72)

64
Switching fabric modules
Table 17 describes the switching fabric modules available for the S9810 switch.
Table 17 Switching fabric module specifications
Model Item Specifications
• LSVM1SRPC1
• LSVM1SRPA1
Interfaces
• 1 console port
• 1 × 10/100/1000Base-T port for management and upgrade
• 1 USB port (USB 2.0, Host)
Transmission rate
• Console port: 9600 bps (default) to 115200 bps
• 10/100/1000Base-T port: 10/100/1000 Mbps
Transmission
medium and max
transmission
distance
• Console port: 15 m (49.21 ft) over asynchronous serial cable
• 10/100/1000Base-T port: 100 m (328.08 ft) over category-5
twisted pair cable
Power modules
The PSR1800-56A power module is available for the switch. The PSR1800-56A power module is an
AC-input and DC-output power module that provides a maximum output of 1800 W.
The S9804 switch supports 1+1 power redundancy. The S9810 switch supports N+1 or N+N power
redundancy. N can be 1 or 2. The number of power modules that a switch requires is determined by the
power supply mode and system power consumption. Make sure the total maximum output power of the
installed power modules is greater than the system power consumption. H3C recommends that you
reserve 20% of the maximum output power.
Table 18 describes PSR1800-56A power module specifications.
Table 18 PSR1800-56A power module specifications
Item PSR1800-56A
Rated input voltage range 100 VAC to 240 VAC @ 50/60 Hz
Maximum input current 13 A
Output voltage –56 VDC
Output current
• 32.2 A (201 VAC to 240 VAC)
• 19.6 A (100 VAC to 200 VAC)
Maximum output power
• 1800 W (201 VAC to 240 VAC)
• 1100 W (100 VAC to 200 VAC)
Operating temperature –10°C to +55°C (14°F to 131°F)
Relative humidity 5% to 95%
NOTE:
You can install one power module if the input voltage is in the range of 200 VAC to 240 VAC. You must
install two power modules if the input voltage is in the range of 100 VAC to 200 VAC.