H3C Technologies H3C S9800 Series Switches - Manual (Page 26)

18
Figure 24 Installed slide rails
Mounting the S9810 switch in the rack
This task requires two people. To mount the switch in the rack:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Verify that the mounting brackets and grounding cable have been securely attached to the switch.
3. Verify that the slide rails have been reliably attached to the rack posts.
4. Install cage nuts to the front rack posts.
5. Use two people to lift the chassis into position between the rack posts.
6. Place the chassis on the guide rails of the slide rails and slide the chassis slowly into the rack until
the mounting brackets are flush with the front rack posts, as shown in
Figure 25 .
7. Use screws provided with the switch to attach the mounting brackets to the front rack posts, as
shown in Figure 25 .