H3C Technologies H3C S9800 Series Switches - Manual (Page 37)

29
Figure 36 Installing a power module
NOTE:
To ensure good ventilation, install a filler panel into the power module slot immediately when the slot is
empty.
Connecting the power cord
IMPORTANT:
•
Use the power cord and the C15 connector supplied with the power module.
• Switch off the input circuit breaker before you connect the power cord to the switch.
Connecting an AC power cord to the switch
1. Connect one end of the AC power cord to the AC-input power receptacle on the switch.
2. Use cable tie to secure the power cord to the power module handle, as shown in Figure 37 .
3. Connect the other end of the power cord to the AC power outlet.