H3C Technologies H3C S9800 Series Switches - Manual (Page 33)

25
Installing fan trays
Installing the LSVM1S9800FAN/LSVM2S9800FAN fan tray
for the S9804 switch
CAUTION:
•
Do not power on the switch when the switch does not have any fan trays installed.
• You must install two fan trays of the same model on the S9804 switch.
The installing and removing procedures are the same for the LSVM1S9800FAN and LSVM2S9800FAN
fan trays.
To install an LSVM1S9800FAN/LSVM2S9800FAN fan tray:
1. Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.
2. Use a Phillips screwdriver to loosen the captive screws on the filler panel in the fan tray slot.
3. Thread a flat-blade screwdriver through the handle on the filler panel and pull out the filler panel
gently.
Keep the filler panel secure for future use.
4. Unpack the fan tray and verify that the fan tray model is correct.
5. Holding the fan tray with both hands with the upside (marked with a "TOP" sign) up, gently push
the fan tray into the slot along the guide rails until the fan tray completely seats into the slot. See
callout 1 in Figure 31 .
To prevent damage to the fan tray or the connectors on the backplane, insert the fan tray gently.
If you encounter resistance while inserting the fan tray, pull out the fan tray and insert it again.
6. Use a Phillips screwdriver to tighten the captive screws on the fan tray to make sure the fan tray
fully seats into the slot. See callout 2 in
Figure 31 .
If the screws fail to be tightened, verify the installation of the fan tray.
Figure 31 Installing the LSVM1S9800FAN/LSVM2S9800FAN fan tray
1
2
2
2
2