ARM Electronics JHD - Manual (Page 35)

JPEG2000 Stand alone DVR User Guide
- 35 -
4-4-2 Schedule record
Program a recording schedule throught out the week.
MODE: Press MODE to select an editing mode. Use the direction keys
to move the cursor, and then press [+] and [-] to select a recording
mode.
The editing modes are as below:
TIME CELL: Program the schedule at a two-hour interval.
TIME ZONE: Program the schedule by time zone. There are 12 Time Zones in
the setting. A time zone is a two-hours interval from Sunday to Saturday.
WEEK: Program the schedule day by day.
ALL: The DVR records at one recording mode, 24 hours a day, 7 days a week.
CLEAR ALL: Clear all the schedule settings
NEXT: Go to the next page. The first page is from 00-12, and the second
page is from 12-24.
Set up a recording mode:
A- ALARM REC / M- MOTION REC / C- CONTINUOUS REC
---: No schedule recording
A--: Set as Alarm record. When there is an alarm triggered, the DVR records at
the speed set in RECORD IN ALARM.
-M-: Set as motion record when there is motion detected, the DVR records at
the speed set in RECORD IN MOTION.
--C: Set as continuous record. The DVR records continuosly at the speed set in
CONTINUOUS RECORD.
AM-: Set as Alarm+Motion record. The DVR records at the speed set in
RECORD IN ALARM when there is an alarm triggered, and at the speed set in
RECORD IN MOTION where there is motion detected.
A-C: Set as Alarm+Continuous record. The DVR records continuosly at the
speed set in CONTINUOUS RECORD, and switches to the speed set in
RECORD IN ALARM when there is an alarm triggered.
-MC: Set as Motion+ Continuous record. . The DVR records continuosly at the
speed set in CONTINUOUS RECORD, and switches to the speed set in
RECORD IN MOTION when there is motion detected.
Time Cell
Time Zone
Week
1. If the DVR is set to MOTION RECORDING and the DVR keeps recording continuously or is
not triggered to record as you expect, please check the sensitivity settings and the motion
mask setup in CONFIGURATION＞CAMERA SETUP＞MOTION SETUP.
2. If the motion settings are too sensitive, you may want to lower the sensitivity level and define
a motion detection area for more accuracy. If the motion is not triggered as your expectation,
you may want to increase the sensitivity level, clear the motion mask, or enlarge the
detection area.