ARM Electronics JHD - Manual (Page 32)

JPEG2000 Stand alone DVR User Guide
- 32 -
4.[ALARM ACTIVE]
Turn on/off the beep when an alarm is triggered.
5.[MOTION DETECT]
Turn on/off the beep when motion is detected.
4-3-8 Password setup
The password consists of 1 to 8 digits. Press the number keys on the front panel to
enter the password and you can use any combination of the numbers from 1 to 10 .
1.[USER ID]
Press e or f to set User ID.
2.[USER PW]
Key in the current password.
3.[NEW PW]
Key in the new password.
4.[CONFIRM PW]
Enter the new password again for confirmation.
The three user levels have different authorities to operate the DVR.
Change Settings Clear HDD Change Password Playback & Search Remote Access
Admin ○ ○ ○ ○ ○
Manager ○ U ○※ ○ U
User U U U ○ U
※It can change Manager ‘s and Users’ password.
4-3-9 System information
Indicate the system information and its status.
S/W version: Indicate the firmware version
H/W version: Indicate the PCB version
Product ID: Indicate the product ID number
MASTER: Indicate the information of MASTER HDD
SLAVE: Indicate the information of SLAVE HDD
CD-R: Indicate the information of CD-R
Default password:
ADMIN: (NULL) / MANAGER:
“1” / USER1: “2” ~ USER8:
“9”
1. When the buzzer is triggered to beep, press any button on the front panel to turn off the
Beep.
2. The beeping can only be turned off manually. There is no time out setup to turn off the
Beeping automactically.
The product ID is not the DVR’s MAC address. MAC address can be found in
[EXTERNAL DEVICE] ＞ [TCP/IP setup].