ARM Electronics JHD - Manual (Page 29)

JPEG2000 Stand alone DVR User Guide
- 29 -
[CAMERA COLOR SETUP]
Adjust the image color: Use [UP] and [DOWN] to select an item and use [-] and
[+] or Jog shuttle to adjust the values.
CHANNEL: Select the camera to be modified.
BRIGHTNESS: Adjust image brightness (-32~31).
CONTRAST: Adjust color contrast (-32~31).
SATURATION: Adjust color saturation (-32~31).
HUE: Adjust color hue (-32~31).
SCREEN POSITION: Adjust camera image horizontal display position.
[CAMERA ACTIVE SETUP]
Use the direction buttons to select an item and press [ENTER] to select ON
and OFF. If a channel is set to OFF at LIVE and ON at RECORD, the channel
will be recorded, displayed during Playback, but will not be displayed at LIVE.
1.[STATUS]
Indicate the camera status: ACTIVE means the video input status is normal,
and LOSS means the video is lost.
2.[LIVE]
Set up the channel to be displayed or not at the LIVE screen.
3.[REC]
Set up the channel to be recorde or not.
[MOTION SETUP]
1.[CHANNEL]
Select a channel for the setup.
2.[SENSITIVITY GRADE]
Adjust motion detection sensitivity. 1 (LOW)~4 (VERY HIGH)
3.[MOTION DISPLAY TYPE]
Setup the display type that marks the motion area.
BOX- shows block / CELL- shows green lattice
4.[RECORD DURATION]
The DVR record for duration from the time motion is detected. If the DVR
detects motion continuosly, the DVR keeps recording through out the event, and the duration after the last motion
event. For example, the duration is set to 10 seconds and the motion last for 3 minutes. The DVR records for 3
minutes and 10 seconds.
5.[NUMBER OF CELLS TO DETECT]
It will only be triggered when the cells in motion are MORE THAN the number the user has set.So the smaller
the number is, the more sensitive the detection is.