AML M2500 Decoder - Manual (Page 9)

5
MSR LASER
AMERICAN
MICROSYSTEMS
MICROSCANNER
POWER WAND
NOTE: A 12V LASER will require a 12V regulated external
power supply. See the APPENDIX at the back of
this manual for a description of "External Power
Supply Requirements".
Installing A Slot Reader (Badge Reader)
Plug the end of the SLOT READER cable into the circular
connector labeled "WAND" on the front panel of the reader.
Step 7: Plug the power supply into the rear panel of the reader
labeled "EXT POWER".
HOST TERMINAL
EXT.
POWER