AML M2500 Decoder - Manual (Page 44)

40
POSTAMBLES
POSTAMBLE refers to a user-defined set of characters transmitted at
the end of each type of input data. There are two different postambles.
One set for bar code data, and one set for magnetic stripe data.
0) ENTER BAR CODE POSTAMBLE
This set of user-defined characters is transmitted at the end of
bar code data. To define this postamble, scan up to 15
characters from the FULL ASCII section of the MENU and then
scan the "ON" bar code when you are done.
1) ENTER MAG STRIPE POSTAMBLE
This set of user-defined characters is transmitted at the end of
mag stripe code data. To define this postamble, scan up to 15
characters from the FULL ASCII section of the MENU and then
scan the "ON" bar code when you are done.
2) BAR CODE SEND DELAY (0.0 - 9.9 SEC)
This option specifies the amount of delay to occur after the bar
code postamble is transmitted. The delay period is
programmable from 0.0 to 9.9 seconds.
3) MAG SEND DELAY (0.0 - 9.9 SEC)
This option specifies the amount of delay to occur after the
mag stripe postamble is transmitted. The delay period is
programmable from 0.0 to 9.9 seconds.
4) ACTIVE TYPES
Specifies the types of bar codes that can accept appended
postambles. Select one of the following:
A CODE 39 G CODABAR
B UPC-A H CODE 128
C UPC-E I CODE 93
D EAN-13 J MSI/PLESSEY
E EAN-8 K CODE 11
F INTERLEAVED 2 of 5 L ISBN
X* ALL BAR CODES