Video world – AML M2500 Decoder User Manual

Page 25

SLOT READER (Badge Reader)

Step 1:

Hold the CARD so that the bar code label is on the bottom and

FACES the ARROW on the slot reader.

Step 2:

Insert the CARD into the opening on either side of the reader.

Step 3:

Holding the CARD flat against the bottom of the reader, SLIDE the

card through the opening. You can slide the CARD bi-directionally

(either left-to-right or right to left) and the data will output correctly

to your computer. The CARD must maintain contact with the base

of the reader while scanning. The front panel "POWER" light will

change to RED while the card is being pulled through the SLOT

READER.

NOTE: The center of the bar code must be positioned 0.5" from

the bottom edge of the card.

Step 4:

After a successful read the following will occur:

The reader will BEEP.

The bar code data is transmitted to the computer.

Step 5:

When the front panel "POWER" light changes to GREEN, the

reader is ready to scan another card.

VIDEO WORLD

ID CARD

837611