AML ACC-7037 4-Position Battery Charger - Manual

User’s Guide
ACC-7037
4-Position
Battery Charger
© 2013 AML
2190 Regal Parkway • Euless, TX 76040
800.648.4452 • Local: 817.571.9015
www.amltd.com • 800.648.4452
© 2013 AML
Regulatory Information
All American Microsystems, Ltd. devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required. Any changes or modifications to American
Microsystems, Ltd. equipment, not expressly approved by American Microsystems, Ltd., could void the
user's authority to operate the equipment.
Power Supply
Use only an American Microsystems, Ltd. approved Power Supply, output rated 12 VDC and minimum
5A. The Power Supply is certified to EN60950.
Disclaimer
American Microsystems, Ltd. reserves the right to make changes in specifications and other information
contained in this document without prior notice, and the reader should in all cases consult American
Microsystems, Ltd. to determine whether any such changes have been made. The information in this
publication does not represent a commitment on the part of American Microsystems, Ltd.
American Microsystems, Ltd. shall not be liable for technical or editorial errors or omissions contained
herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use
of this material.
This document contains proprietary information that is protected by copyright.
All rights are reserved. No part of this document may be photocopied, reproduced, or translated into
another language without the prior written consent of American Microsystems, Ltd.
FCC Declaration of Conformity
Product Name: 4-Position Battery Charger
Model Number: ACC-7037
Radio Frequency Interference Requirements
This equipment complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This equipment may not cause harmful interference, and (2) this equipment must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential environment. This equipment
generates uses and can radiate radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If you determine the equipment does
cause harmful interference to radio or television reception (this may be determined by monitoring the
interference while turning the equipment off and on), you are encouraged to try to correct the interfer-
ence by one of the following measures:
·
Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
· Consult the dealer or an experienced radio or TV technician for help.
Radio Frequency Interference Requirements - Canada
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Marking and European Economic Area (EEA)
Products intended for sale within the European Union are marked with
the CE mark which indicates compliance to applicable Directives and
European Normes (EN), as follows. Amendments to these Directives or EN’s are included.
· Electromagnetic Compatibility Directive 89/336/EEC
· Low Voltage Directive 73/23/EEC
Safety ---- NOM / NYCE-NOM-001-SCFI-1993
Electronic Apparatus: Household electronic
apparatus powered by different sources of
electrical energy.