AML M2500 Decoder - Manual (Page 41)

37
4) SEND DAISY CHAIN ID (ON/OFF)
ON Sends the daisy chain ID at the beginning of data
transmit, when in the daisy chain mode.
OFF* Does not send daisy chain ID.
5) HOST RESPONSE (ON/OFF)
ON Unit requires receipt of a Host Response after
each data transmit. When used during daisy chain
mode, the command must be preceeded by the
daisy chain ID.
OFF* Unit does not require a Host Response.
Valid Host Responses are:
CTRL G (ASCII 7) - Single Beep.
CTRL R (ASCII 18) - High/Low warble tone.
CR (ASCII 13) - Data OK. No action
needed.
6) HOST RESPONSE TIMEOUT (00-99 SEC)
This parameter specifies how long the M2500 will wait for the
host response. If the response timeout is set to zero then the
M2500 will wait indefinitely. If a response is not received
within the timeout period, the M2500 will continue scanning.
The host response delay is programmable from 0-99 seconds.
7) HOST BEEP ENABLE (ON/OFF)
ON Enables receipt of commands from the Host
Computer. These commands can be sent at any
time.
CTRL G (ASCII 7) - Single Beep.
CTRL R (ASCII 18) - High/Low warble tone.
OFF* Disables Host Commands.