AML M2500 Decoder User Manual

Page 56

Step 6:

Scan the following "CLONE" bar code:

Step 7:

Once the clone information has been transmitted, take any steps

required to save the information on the computer.

Step 8:

From the SOURCE reader, scan EXIT (saving OR ignoring

changes) on the READER SETUP MENU.

Step 9:

Disconnect the SOURCE reader from all cables leading to the

computer.

Step 10:

Plug the 9 pin end of the PC CLONE CABLE into the reader which

is to receive the clone information (denoted as the "TARGET"

reader). The TARGET reader's connector, located on the rear

panel, is labeled "HOST".

Step 11:

At the computer, run the communications program. Note that the

communications BAUD RATE must be set to match the TARGET

reader's BAUD RATE (the default setting is 9600).

Step 12:

Set the communications program to TRANSMIT. The reader will

beep twice, pause, and beep three times more, indicating the

following:

2 beeps:

indicate the clone information was received

3 beeps:

indicate the reader is now configured

Step 13:

Now you are ready to disconnect the newly configured reader from

all cables leading to the computer.

Step 14:

Repeat steps 10 -14 for each additional reader to be cloned.

CLONE