Filter service – Airaid 883-282 User Manual
Page 4
36. Slide the Riser Tube Gasket (#23) on to the Thread-
ed Studs.
37. Slide the Riser Tube with Studs and gasket through
the panel as shown.
38. Mount the Air Inlet Scoop.
A.) Slide the Air Inlet Scoop(#6) and Air Scoop Gas-
ket (#24) onto panel and Studs.
B.) Fasten the Scoop to the Riser Tube Studs using
the three 1/4-20 Flange Nuts (#18) and 1/4”Flat wash-
ers.
39. Re install the panel, Scoop, and Riser Tube onto the
vehicle. Slide the Hump Hose and clamps onto the Air
Box Inlet, and tighten the Clamps.
Reinstall the remaining factory panels and the bed in
the reverse order in which they were removed.
40. Insert the Foam Pre Filter (#6) into the Air Scoop
as shown.
41.
Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Reconnect the neg-
ative battery cable and reinstall the seats.
1. Loosen the Clamps on the Hump Hose and slide it
back. Remove the 1/4” bolts and washers from the Air-
Box Top and slide out the Top
Filter Service
Airaid recommends following the manufacturers maintenance schedule for filter cleanings.
“Air filters should be inspected before each ride. Filter and pre-filter need to be replaced at least annually and more often if subjected to severe use.”
The Airaid filter is reusable and should be cleaned using the Airaid Filter Tune-Up Kit .
The Foam Pre Filter is reusable and can be cleaned using a mild detergent and water.
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
3. . The Filter can now be removed for service and in-
spection. Thoroughly inspect the interior of the Air Box
for water and large pieces of debris that may have been
ingested.
2. Remove the Plug Grommet in the access port and
loosen the filter Clamp. A 1/4” drive ratchet with a 3”
extension and a 5/16” socket works best.
Gasket
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
Page 4