Airaid 200-108 - Manual

Installation Instructions
For Part Numbers :
200-108
700-430 Airaid Oiled Media Filter
201-108 701-430 SynthaMax Dry Media Filter - Red
202-108 702-430 SynthaMax Dry Media Filter - Black
203-108 703-430 SynthaMax Dry Media Filter - Blue
1996-05 Chevrolet S-10 Blazer/GMC Jimmy
1996-04 Chevrolet S-10/GMC Sonoma
1997-00 Isuzu Hombre
1991-01 Oldsmobile Bravada
4.3L V6
Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Stainless Coupler 1
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number,
and click View Details.
1) DISCONNECT NEGATIVE (-) BATTERY CABLE.
2) Remove the Factory Air Filter Housing.
A) Unscrew the air cleaner housing lid from the base.
B) Loosen the rubber clamp to the mass air flow meter and remove from vehicle. See Fig#1
C) Remove the factory air filter from the vehicle. See Fig#1
D) Remove the air filter housing base by removing the one nut on the corner of the housing. Then lift the housing out from
the rear to remove.
3) Install the Airaid Intake Tube.
A) Mount the 3.5” stainless steel coupler onto the long end of the Airaid intake Tube.
B) Slide the tube with coupler onto the mass airflow meter. (Note: the coupler is a reducer, the smaller end of the coupler
mounts onto the meter.)
C) Install the Airaid premium air filter to onto the short end of the intake tube and tighten hose clamp.
D) Slide the Airaid intake tube with coupler over the mass air meter and align bracket with the factory stud. See Fig#2
E) Use the original 10mm nut to fasten the Airaid bracket to the factory stud. See Fig#2
F) Carefully tighten the stainless coupler in alternating steps.
4) Finishing Up
A) Check for any foreign objects or debris in the intake path.
B) Reconnect the negative battery cable & double check your work.
Fig#1 Fig#2