Airaid 200-111 - Manual

Installation Instructions
For Part Numbers:
200-111 720-472 Airaid Oiled Media Filter
201-111 721-472 SynthaMax Dry Media Filter - Red
202-111 722-472 SynthaMax Dry Media Filter - Black
203-111 723-472 SynthaMax Dry Media Filter - Blue
2014-15 Chevrolet Silverado & GMC Sierra
2015 Cadillac Escalade
2015 GMC Yukon Denali & Denali XL
6.2L V8
2. Using an open end wrench, remove the passenger
side fender brace and set it aside. Unplug the Mass Air
Flow sensor, or MAF and un anchor it from the airbox.
Unseat the airbox from it’s mounting grommets and
remove the factory airbox. 3. . Remove the 4 bolts in the airbox mounting tray and
set them aside. They will be reused in step 5. Remove the
Tray, it will not be re used.
4. Install the Filter Adapter onto the Cold Air Box as
shown using the three 1/4-20 Button Head Screws (#16)
and 1/4” Flat Washers (#19). 5. Slide the Airbox assembly into the inner fender area
and secure it using 3 of the OEM bolts removed in step
3.
6. Install the Barbed Fitting and Elbow (#s 13 and 14)
into the Airaid Intake Tube as shown.
8. Slide the Hump Hose with the #68 Hose Clamps
onto the Filter Adapter and the Reducing Coupler with
the #60 and #56 Clamps onto the throttle body. Leave
the clamps loose for now. 7. Transfer the Mass Air Flow sensor from the factory
airbox into the Airaid Intake Tube. Secure the sensor
using the two 8-32 Button Head Screws (#17).
Do Not Use Factory Hardware ! 9. Install the Airaid Intake Tube into the Hump Hose and
couplers. Adjust for fit and tighten all four Hose Clamps.
Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Cold Air Box 1
4. Filter Adapter 1
5. Silicone Hump Hose 1
6. Silicone Reducing Coupler 1
7. 5/8" x 12” Breather Hose 1
8. 5/8" x 9.5" Breather Hose 1
9. Weather Strip 25 ½” 1
10. #68 Hose Clamp 2
11. #60 Hose Clamp 1
12. #56 Hose Clamp 1
13. #19 Speed Clamp 4
14. 3/8" NPT x 5/8" Barb Elbow 1
15. 3/8" NPT x 5/8" Barb Fitting 1
16. ¼-20 x 1/2” Button Head Cap Screw 3
17. #8-32 x ½” Button Head Cap Screw 2
18. SAE 90 Deg. Quick Connect Fitting 2
19. 1/4” Flat Washer 3
1.Disconnect The Negative Battery Terminal!
A. Depress the Grey locking tabs in the PCV breather
quick connect fittings and remove them from the vehi-
cle.
B. Loosen the clamps on the factory intake assembly
and remove it from the vehicle.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
A
B
Fender Brace
MAF
Elbow
Fitting
#68 Clamps
#56 Clamp
#60 Clamp