Airaid 200-180 - Manual

Installation Instructions
For Part Numbers:
200-180
700-451 Airaid Oiled Media Filter
201-180 701-451 SynthaMax Dry Media Filter - Red
202-180 702-451 SynthaMax Dry Media Filter - Black
203-180 703-451 SynthaMax Dry Media Filter - Blue
2006-07 Hummer H3
3.5L I5, 3.7L I5
Component Identification
1. Airaid Premium Filter 1
2. Front Panel Coated 1
3. Rear Panel Coated 1
4. Weather Strip 22” 1
5. 6-32x 5/16" Screw 4
6. #6 Flat Washer 4
7. 6-32 Keps Nut 4
5. Install the Airaid Premium Filter (#1) on the factory intake
tube.
1. Disconnect the negative battery cable.
Unhook the three clips that hold down the air box lid.
3. Remove the factory air filter from the airbox. Do not remove
the factory airbox base. The factory base is required to mount
the Airaid Quick Fit Panel.
2. Remove the lid by lifting, and sliding it out of the tabs on the
side of the airbox.
6. Make sure the filter and the hose clamp are pushed close to
the factory airbox wall, and tighten the hose clamp as shown.
Do Not over tighten.
4. Assemble the Airaid Quick Fit Panels (#2, #3) using four 6-
32x 5/16” screws (#5), #6 flat washers (#6), and 6-32 keps nuts
(#7).
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.