Airaid 200-225 - Manual

Installation Instructions
For Part Numbers:
200-225
700-469 Airaid Oiled Media Filter
201-225 701-469 SynthaMax Dry Media Filter - Red
202-225 702-469 SynthaMax Dry Media Filter - Black
203-225 703-469 SynthaMax Dry Media Filter - Blue
2007-08 Chevrolet Silverado 2500HD/3500HD/ Suburban 2500
2007-08 GMC Sierra 2500HD/3500HD/ Yukon XL 2500
6.0L V8
*New Body Style Only*
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel 1
3. Rear Air Dam Panel 1
4. Airaid Intake Tube 1
5. Air Filter Adapter 1
6. Urethane Hump Hose 1
7. Coupler W/#68 Hose Cl. 1
8. 3/8” x 8” Breather Hose 1
9. Weather Strip 20 3/4” 1
10. 6-32 x 5/16” Screw 5
11. #6 Flat Washer 5
12. 6-32 Keps Nut 5
13. 1/4 - 20 x 1/2” Button Head Bolt 3
14. 1/4” Flat Washer 7
15. M6 - 1 x 25 Hex Bolt 4
16. #64 Hose Clamp 2
17. 1/4” NPT x 3/8” Barb Fitting 1
1. Disconnect the negative battery cable.
Remove the factory beauty cover by lifting up on
the front, and then pulling the cover towards the
front of the vehicle. It is only held in place by
grommets. 2. Disconnect the factory breather hose at the
valve cover. 3. Separate the factory intake tube from the plas-
tic clamp that secures the radiator hose to the
tube. A firm downward push will usually do it.
4. Loosen three hose clamps. One at each end of
the factory intake tube, and one on the Mass Air
Flow sensor (MAF) wher e it clamps to the fac-
tory airbox. Remove the factory intake tube from
the vehicle.
5. Remove, and set aside the MAF (Mass Air
Flow) sensor fr om the factor y air box using
caution to retain the factory clamp and seal.
6. Rock the factory airbox back and forth to loos-
en it from the mounting grommets, and remove it
from the vehicle.
7. Using a 10mm socket, remove four bolts, and
then remove the factory airbox mounting plate
from the vehicle. 8. Assemble the Cool Air Dam panels (CAD) (#2
& #3) using five 6-32 x 5/16” screws (#10), #6
flat washers (#11), and 6-32 keps nuts (#12).
Next install the air filter adapter (#5) into the pan-
els as shown using three 1/4 - 20 x 1/2” button
head bolts (#13), and 1/4” flat washers (#14). 9. Install the Airaid CAD assembly into the vehi-
cle replacing the factory airbox. Secure the CAD
using four M6 x 1.25 Hex Bolt (#15), and 1/4”
flat washers (#14). Do not over tighten the four
bolts.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.