Airaid 883-282 - Manual (Page 2)

12. Remove the two rivets holding the intake shroud
to the frame. Then remove the shroud and set it aside. 13. Remove the last three rivets securing the drivers
side quarter panel. Remove the panel from the vehicle.
10. Remove the nylon rivet securing the bed to the panel
on both sides of the vehicle.
Page 2
14. Disconnect the PCV breather from the fitting in the
factory filter housing. Remove the spring clamp from
the breather line and discard. It will not be reused.
9. Underside view of fourth screw in need of removal.
15. Loosen the large clamp on the factory intake tube
16. Remove the two bolts at top of the factory air filter
housing and remove the entire housing from the vehi-
cle. 17. Prepare the Filter Adapter (#7) for installation by
aligning the bolt holes with those on the Adapter Gasket
(#21).
18. Mount the Filter Adapter and gasket inside the
Airaid Cold Air Box (#2) using three 1/4-20 x 5/8”
Hex Bolts (#12), 1/4” Flat Washers (#14), and 1/4”
Nylock Nuts (#17). 19. .Insert the Airaid Premium Filter (#1) into the Cold
Air Box and onto the Filter Adapter. 20. Rotate the filter inside the Air Box until the clamp
adjuster lines up in the center of the access port. Tighten
the clamp.
11. Completely remove the bed and set it aside.
21.
A.) Tr ansfer the OEM PCV fitting fr om the facto-
ry filter housing into the Airaid Air Box as shown.
B.) Install the Plug Gr ommet (#28) into the access
port. 22. Install the 1/8” NPT Drain Plug (#25) into the
Airaid Air Box.
Note: This Plug is designed to be used as a water drain
from the lowest point of the intake in the event of water
ingestion. If at any point you suspect you may have
ingested water, or are uncertain, remove plug for in-
spection. 23. Mount the Transmission Bracket (#9) to the Air
Box using two1/4-20 x 5/8” Hex Bolts, and 1/4” Lock
Washers (#15).
A
B