Airaid 200-189 - Manual

1. Disconnect the negative battery cable.
Using a 5/16” socket or flat screwdriver, loos-
en the hose clamp that holds the factory airbox
to the flexible intake tube. 2. Using a #20 Torx bit, remove 2 screws hold-
ing the Mass Air Flow sensor to the factory air-
box tube. 3. Without disconnecting the wiring harness,
remove the Mass Air Flow sensor from the
factory airbox, and set it aside.
4. Slide the flexible intake tube off of the facto-
ry airbox and then rock the airbox back and
forth to free it from the mounting grommets,
next lift it straight up and remove it from the
vehicle. 5. Remove the factory filter minder and grommet
from the factory airbox. Save them for later use. 6. Using a 10mm socket, remove 5 bolts from the
factory airbox mounting plate. Remove the plate
from the vehicle.
7. Assemble the two Cool Air Dam panels (#2)
and (#3) as shown, using the five 6-32 screws
(#10), washers (#11), and nuts (#12) 8. Install the Airaid intake tube (#4) into the Cool
Air Dam using the thr ee 1/4”-20x1/2” button
head bolts (#6), and washers (#7) as shown. 9. Re-install the factory grommet and filter
minder removed in step #5 into the Airaid intake
tube.
Installation Instructions
For Part Numbers:
200-189
700-469 Airaid Oiled Media Filter
201-189 701-469 SynthaMax Dry Media Filter - Red
202-189 702-469 SynthaMax Dry Media Filter - Black
203-189 703-469 SynthaMax Dry Media Filter - Blue
2006 GMC Sierra 2500HD/3500HD
2007 GMC Sierra “Classic” 2500HD/3500HD
6.6L V8 Duramax Diesel “LLY” or “LBZ”
With Low Profile Hood
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel 1
3. Rear Panel 1
4. MAF Adapter Tube 1
5. Weather Strip 20 3/4” 1
6. 1/4”-20x1/2” Button Head 3
7. 1/4” Flat Washer 7
8. 8-32x1/2” Button Head Screw 2
9. M6-1x25 Hex Bolt 4
10. 6-32x 5/16” Screw 5
11. #6 Flat Washer 5
12. 6-32 Keps Nut 5
13. Rubber Trim 6 1/2” 1
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.