Airaid 883-274 - Manual

Installation Instructions
For Part Number:
883-274 Intake Kit
2009-13 Kawasaki Teryx
750cc F.I.
2. The engine covers needing to be removed for this
installation are primarily held in place with the use of
nylon rivets. Nylon rivets are reusable if care is taken
during their removal and installation. Using a small
standard blade screwdriver, gently pry up on the center
post until the entire rivet can be pulled freely from the
panel. Rivet installation is the opposite. 3. Locate and remove the two nylon rivets on either side
of the small cover. Remove the cover and set it aside. It
will be reused.
4. Remove the engine cover.
A.) Remove the thr ee small nylon r ivets, two on the
drivers side, one on the passenger side.
B.) Remove the two Phillips head scr ews, one on
each side.
C.) Remove the two large nylon r ivets, one on each
side.
Pull the cover up and forward clearing the levers and
seat belt buckles. 5. Remove the factory airbox assembly.
A.) Loosen the hose clamp on the air box coupler .
B.) Using a 10mm socket, r emove the two factor y
airbox mounting bolts on either side.
Lift the factory airbox up and out of the vehicle. 6. Prepare the Filter Adapter (#4) for installation by at-
taching the gasket (#13) and lining up the bolt holes.
8. Install the Silicone Reducer (#5) and Hose clamps
onto the CAB. Place the #64 clamp (#12) on the larger
side of the reducer, and the #52 clamp (#11) on to the
smaller side. 7. Install the Filter Adapter on the Cold Air Box, or
CAB (#2) as shown using thr ee 1/4-20 x 5/8” Bolts
(#6), 1/4” lock washers (#10), and 1/4”Flat washers
(#9). Do not over tighten. 9. Install the CAB assembly onto the factory plenum and
tighten the Hose Clamps.
C.
Component Identification
1. Airaid Premium Filter 1
2. Cold Air Box 1
3. Air Box Top 1
4. Filter Adapter 1
5. Reducing Coupler 1
6. 1/4-20 x 5/8” Hex Head Bolt 5
7. 1/4-20 x 1” Hex Head Bolt 4
8. M6 x 1.0 x 25 Hex Head Bolt 2
9. 1/4” Flat Washer 11
10. 1/4” Lock Washer 11
11. #52 Hose Clamp 1
12. #64 Hose Clamp 1
13. Adapter Gasket 1
14. Bubble Sticker 1
15. Airaid Pre Filter 1
Tools Required For Installation:
7/16” Wrench, 10mm, 7/16” Sockets
Ratchet & Extension
Phillips and Standard Tip Screwdrivers
1. Remove both the driver and the passenger side seats.
Disconnect the negative side battery terminal.
B. A.
A.
B.
#64
#52
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.