Airaid 450-327 - Manual

Installation Instructions
For Part Numbers:
450-327 700-495 Airaid Oiled Media Filter
451-327 701-495 SynthaMax Dry Media Filter - Red
452-327 702-495 SynthaMax Dry Media Filter - Black
453-327 703-495 SynthaMax Dry Media Filter - Blue
2015 Ford Mustang
3.7L V6
2. Disconnect the 2 breather lines from the intake tube,
loosen the hose clamps and remove the factory intake . 3. Remove the 6mm airbox mounting bolt in the inner
fender and lift the entire airbox assembly out of the vehi-
cle. Set the bolt aside for now. It will be reused.
4. Be sure to retain the speed clip in the inner fender,
and replace the grommet if it comes out with the air box. 5. Install the Grommets and Aluminum Fittings into the
Airaid Intake Tube. 6. Install the Filter Adapter onto the Cold Air Box as
shown, using three sets of 1/4-20 Button Head Screws
and 1/4” Flat Washers
7. Place the Airaid Airbox assembly into the engine
compartment as shown, with the locator pin on the bot-
tom of the box inside the fender grommet. Secure the
Airbox by reusing the 6mm bolt removed in step # 3.
Component Identification
1 Airaid Premium Filter 1
2 Airaid Intake Tube 1
3 Cold Air Box 1
4 Air Box Window 1
5 Air Box Lid 1
6 Hump Hose 1
7 Reducing Hump Hose 1
8 Filter Adapter 1
9 #48 Hose Clamp 1
10 #64 Hose Clamp 1
11 #68 Hose Clamp 2
12 1/2" ID Grommet 1
13 13/16" ID Grommet 1
14 5/8 Aluminum Fitting 1
15 3/8 Aluminum Fitting 1
16 Button Head Cap Screw 9
17 1/4" Flat Washer 9
1. Remove the battery box cover in the cowl and discon-
nect the negative battery terminal.
FILTER IDENTIFICATION
700-495 Airaid Oiled Media 701-495Airaid SynthaMax Dry Media - Red
702-495 Airaid SynthaMax Dry Media - Black 703-495 Airaid SynthaMax Dry Media - Blue
Grommet
Clip
8. Slide the Hump Hose and #68 Clamps onto the Filter
Adapter as shown. Do not tighten the clamps at this
time. 9. Slide the Reducing Hump Hose with the #48 and 64
Clamps onto the Throttle body.
Bolt
Pin
#64
#48