Airaid 400-194 User Manual
Page 2

14. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Periodically check the tightness of all hose clamps. Double check the
hood clearance.
15. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.23.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
10. Install the Quick Fit Assembly onto the top
of the factory air cleaner base. Start by sliding
the three tabs on the Airaid panel thru the three
slots on the top of the base. Center the panel
assembly, and re-latch the two factory clips.
11. Reconnect the factory intake tube to the
Airaid MAF adapter, and then tighten the hose
clamp.
12. Reconnect the wiring harness to the MAF
sensor.
13. Install the Airaid Premium Filter (#1) into
the MAF adapter, and tighten the hose clamp.
Next install the weather strip (#5) onto the top of
the Quick Fit Panels as shown.
FILTER IDENTIFICATION
700-452 Airaid Oiled Media 701-452 Airaid SynthaMax Dry Media - Red
702-452 Airaid SynthaMax Dry Media - Black 703-452 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.