Double check your work, Reconnect the negative battery cable – Airaid 310-276 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Open and Install the Clamps onto the Coupler as
shown with the #44 clamp on the throttle body (#9) and
the #52 clamp (#8) on the Intake Tube.
10. Slip the Hump Hose Coupler (#5) onto throttle body
WITH OUT the clamps at this time.
11. Insert Airaid Intake tube into the Coupler first, then
rotate the Intake assembly down into the inner fender.
12. Mount the Cold Air Box assembly in the inner
fender using the three 3/8” x 1 1/2” Button Head Bolts
(#14).
18
. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
Reconnect the negative battery cable!
REV.10.15.13
14. Reconnect the air temp sensor.
15. Reconnect the factory crank case breather line to
the Airaid Intake Tube.
16. Slide the Airaid Premium Filter onto the Intake tube
inside the Cold Air box and tighten the clamp.
17. Mount the self adhesive Gasket (#7) onto the under-
side of the Air Box Lid (#6) and peel off the protective
film on the top. Mount the lid onto the Air Box using
four remaining 1/4-20 x 1/2” Button Head Bolts (#10),
and 1/4” Flat washers (#12).
Pre Filter Option: Part Number 799-445
For maximum protection in the harshest environments
Airaid offers a slip on Pre Filter.
- Prolongs Cleaning Intervals
- Water Repellant
- Free Flowing Protection
FILTER IDENTIFICATION
700-458 Airaid Oiled Media 701-458 Airaid SynthaMax Dry Media - Red
702-458 Airaid SynthaMax Dry Media - Black 703-458 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we suggest
using the AIRAID Filter Tune-Up Kit!
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common non-
petroleum all-purpose household cleaner and wa-
ter. Simple Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of air filter
and allow to soak. Then flush filter clean from the
inside out with a garden hose and repeat steps if
necessary. Do not apply high pressure water or air
to clean filter. Allow filter to air dry and reinstall
.