Airaid 310-212 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
For your Oiled media filter
we offer the Airaid Tune Up
Kit!
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter is
reusable and should be cleaned periodically.
13. Install the Panel assembly into the engine compart-
ment as shown. Slide the Mounting bracket underneath
the power steering reservoir and the airbox mounting
post through the grommet in the Panel. Secure the as-
sembly by reusing the bolt from step 12. Connect the
factory intake tube to the Airaid Intake tube and tighten
the clamp.
10. Transfer the factory air inlet from the airbox and into
the Panel assembly.
11. Install the Mounting Bracket (#6) onto the Panel as-
sembly using the two 1/4-20 Button Head Bolts (#8), 1/4”
Flat Washers (#9), and 1/4-20 Flange nuts (#10).
12. Remove the bolt securing the power steering reser-
voir and set it aside. This bolt will be reused in step 13.
to hold the Mounting bracket.
16. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
Reconnect the negative battery cable!
REV.11.11.13
14. On V8 motors, replace the factory crankcase breather
line with the 13” Breather Hose (#5) and connect it to the
Airaid Intake Tube. Disregard the 90 deg. Elbow (#7) it
will not be used.
15. On V6 motors, connect the factory crankcase
breather hard line to the Airaid Intake Tube using the
90 deg. Breather Elbow (#7). Disregard the 13” Breath-
er Hose (#6) it will not be used.
16. Install the Weather Strip (#4) to the top edge of the
panels, and reattach the hood seal.
17. Install the Airaid Premium Filter.
FILTER IDENTIFICATION
700-539 Airaid Oiled Media
701-539 Airaid SynthaMax Dry Media - Red
702-539 Airaid SynthaMax Dry Media - Black 703-539 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and al-
low to soak. Then flush filter clean from the
inside out with a garden hose and repeat
steps if necessary. Do not apply high pres-
sure water or air to clean filter. Allow filter
to air dry and reinstall
.
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray