Airaid 310-200 User Manual
Page 2
22. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight.
23. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.7.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
13. Install the Quick Fit assembly in the bot-
tom of the stock air box by sliding the
four tabs on the back into the slots on the
airbox, once installed, re-hook the two
latches. Next, install the speed clamp
(#10) over the breather hose and connect
it to the Quick Fit assembly as shown.
14. Install the hump hose (#5) and two #60 hose
clamps (#10) on the Quick Fit assembly.
Do not tighten the clamps at this time.
15. Install the reducer (#6) and two #56
hose clamps (#9) on the throttle body as
shown. Do not tighten the clamps at this
time. Secure the breather hose to the air
conditioner line using the supplied zip
tie (#15).
16. Install the supplied grommet (#8) into the
hole in the back of the tube.
17. Carefully install the factory temperature sen-
sor into the grommet. Make sure it is seated
all the way in.
18. Carefully install the end of the Airaid
Intake Tube (#4) into the hump hose,
and then into the reducer on the throttle
body as shown. Adjust the tube as need-
ed, and then tighten the four hose
clamps.
19. Install the Airaid Premium Filter (#1)
on the Quick Fit assembly as shown,
and tighten the hose clamp.
20. Re-align the engine cover with the grom-
mets on the engine, and push down firmly
to re-seat the cover.
21. Re-install the oil fill plug.
First
Second
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
FILTER IDENTIFICATION
700-458 Airaid Oiled Media 701-458 Airaid SynthaMax Dry Media - Red
702-458 Airaid SynthaMax Dry Media - Black 703-458 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.