Airaid 310-200 - Manual

Installation Instructions
For Part Numbers:
310-200
700-458 Airaid Oiled Media Filter
311-200 701-458 SynthaMax Dry Media Filter - Red
312-200 702-458 SynthaMax Dry Media Filter - Black
313-300 703-458 SynthaMax Dry Media Filter - Blue
2006-10 Jeep Commander
5.7L V8
1. Disconnect the negative battery cable.
Loosen the hose clamp on air cleaner box lid.
Twist and remove the breather hose from the
air cleaner box lid.
2. Unhook the two air cleaner lid latches on the
front of the airbox.
3. Remove the air cleaner box lid by sliding it
forward, and then up, and out of the factory
intake tube.
4. Remove factory air filter from the air clean-
er box.
5. Remove, and set aside the oil filler cap.
Use caution not to drop anything into the
engine while the cap is off.
6. Carefully lift up on the engine cover (it is
held in place by grommets, no bolts) to
access the hose clamp on the throttle
body, and 10mm bolt next to the throttle
body.
7. A.) Loosen the hose clamp on the throttle
body. B.) With a 10mm socket, remove the
bolt next to the throttle body that holds the
intake resonator in place.
8. Carefully pull the resonator towards you and
rotate the bottom up to gain access to the tie
wrap holding the breather hose to the rubber
coupler. Cut the tie wrap and discard.
9. Slide the clip off of the resonator that holds
the breather tube in place.
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel 1
3. Front Panel 1
4. Airaid Intake Tube 1
5. 3 1/2”x4 1/2”Hump Hose 1
6. 3 1/2” to 3 3/8” Reducer 1
7. Weather Strip 17 1/2” 1
8. Grommet 1
9. #56 Hose Clamp 2
10. #56 Hose Clamp 2
11. Speed Clamp 1
12. 6-32x5/16” Screw 4
13. #6 Flat Washer 4
14. 6-32 Keps Nut 4
15. Nylon Zip Tie 1
10. Carefully twist and remove the tempera-
ture sensor from the bottom of the reso-
nator, and then remove the resonator
from the vehicle.
11. Assemble the two pieces of the Quick Fit
panels as shown (#2), using the four 6-
32 screws (#12), washers (#13), and nuts
(#14), that are provided in the kit.
12. Install the weather strip (#7) on the
top of the Quick Fit assembly. (Hint:
start at one end, and go towards the
other end, don’t start in the middle.)
A.
B.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.