beautypg.com

Airaid 310-144 User Manual

Installation instructions

background image

Installation Instructions

For Part Numbers :

310-144

700-452 Airaid Oiled Media Filter

311-144

701-452 SynthaMax Dry Media Filter - Red

312-144

702-452 SynthaMax Dry Media Filter - Black

313-144

703-452 SynthaMax Dry Media Filter - Blue

1991-95 Jeep Wrangler 4.0L I6
Does Not Fit Vehicles With Optional Anti-Lock
Brakes

Component Identification

1.

Airaid Premium Filter

1

2.

MAF Panel Black

1

3.

Bottom Panel Black

1

4.

Brace

1

5.

Plastic Intake Tube

1

6.

Weather Strip 32”

1

7.

Hump Hose

1

8.

Coupler

1

9.

½”x10” Hose

1

10.

¼”” Flat Washer

4

11.

#6 Flat Washer

5

12.

6-32 Keps Nut

5

13.

6-32 x 5/16” Screw

5

14.

¼-20 x 5/8” Hex Bolt

3

15.

¼-20 Lock Nut

3

16.

Grommet

1

17.

#44Hose Clamp

2

18.

#52 Hose Clamp

2

19.

Black Speed Clamp

3

20.

Black Speed Clamp

2

21.

¼” Fender Washer

2

22.

¼”NPTx1/2”Barbed Fitting 1

23.

3/8”x4” Hose

1

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

1. Disconnect negative battery cable.
Remove factory valve cover breather
hose from airbox, and valve cover.

2. Unhook vacuum line from airbox,
and remove from vehicle at the can-
ister below the master cylinder.
(Save for later use.)

3. Pry open the plastic clamp that
holds the factory intake tube to the
throttle body. Unhook the 3 metal
latches on the airbox that hold it to the
mounting plate, and remove the intake
assembly.

4. Remove the two grommets from the
airbox mounting plate.

5. Using a 10mm socket, remove the
horn bolt. (Save for later use.)

6. Carefully remove wire loom clamp
from hole in fender.

7. Assemble the Cool Air Dam as
shown using the 5 screws, washers,
and nuts provided.

8. Using a 9/16” wrench, loosen the
nut on the radiator rod support, and
lift it up.

9. Carefully slide the CAD over the
support rod, and then slide the sup-
plied grommet over the rod, and into
the hole in the CAD as shown. Rotate
the CAD and place into position on
the factory airbox mount. Reinstall the
radiator support rod, and tighten the
nut.

10. Install two ¼”-20 bolts and wash-
ers thru the top, and fender washers
and nuts on the bottom, where the
factory grommets were removed

11. Slide the CAD bracket under the
horn mount and reinstall the factory
bolt from step 5.

12. A) Using a ¼”-20 bolt, washers,
and nut, bolt the CAD to the fender. B)
Install the wire loom clamp into the
hole in the CAD, as shown.

B

A

This manual is related to the following products: