Airaid 300-236 User Manual
Page 4
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.15.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
12. Double check your work!
Make sure there is no foreign material in
the intake path. Make sure all clamps, hos-
es, fasteners, and wiring connections are
tight.
13. Reconnect the negative battery
cable!
11. Install the Airaid Premium Filter (#1) onto the
filter adapter and tighten the clamp. Next install the
weather strip (#4) on the top of the CAB as shown.
(Hint: Start at one end of the CAB and work your
way towards the other end.)
10. Install the supplied 3/4” x 2 1/2” hose (#11)
onto the factory crankcase breather tube, and then
insert the 1/2” x 3/4” barbed connector (#9) into the
3/4” hose. Next connect the 1/2” rubber elbow (#7)
from the 1/2” barbed fitting on the filter adapter to
the 1/2” x 3/4” connector. See the line drawing on
the front page for reference.
2004-and later Models: Inser t the 1/2” x 3/4”
connector into the factory breather hose and then
install the rubber elbow between the two 1/2”
barbed fittings, similar to what is shown above.
Rubber Elbow
1/2” x 3/4”
Coupler
3/4” x 2 1/2” Hose
Discard parts # 13 and 14. They
are not used on this application.
FILTER IDENTIFICATION
720-476 Airaid Oiled Media 721-476 Airaid SynthaMax Dry Media - Red
722-476 Airaid SynthaMax Dry Media - Black 723-476 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil. Service
air filter as needed by cleaning with common non-
petroleum all-purpose household cleaner and wa-
ter. Simple Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of air filter
and allow to soak. Then flush filter clean from the
inside out with a garden hose and repeat steps if
necessary. Do not apply high pressure water or
air to clean filter. Allow filter to air dry and rein-
stall
.