Airaid 300-192 User Manual
Page 2
7. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps and hoses are tight.
8. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.5.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
5. Slide the factory intake tube all the way onto the Quick Fit
Panel tube and tighten the hose clamp. Slip the #24 speed
clamp(#4) over the factory breather hose and re-connect the
factory breather hose to the nipple on the Quick Fit Panel.
Squeeze the speed clamp to secure the breather hose.
6. Install the Airaid Premium Filter (#1) onto the tube of the
Quick Fit Panel as shown, and tighten the hose clamp.
Now install the weather strip (#3) on top of the Quick Fit
Panel. (Hint: Start with the end of the weather strip at one
corner, and work your way around to the other corner.)
FILTER IDENTIFICATION
700-445 Airaid Oiled Media 701-445 Airaid SynthaMax Dry Media - Red
702-445 Airaid SynthaMax Dry Media - Black 703-445 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.