Airaid 300-190 User Manual
Page 2
16. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, fasteners, and wiring connections are tight.
17. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.4.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
13. (Note: Because factory production toler-
ances vary, it may be necessary to remove the
tape on the wiring loom and pull out 1 1/2” of
wire to the temp sensor, and then re-install the
tape. Re-connect the wiring harness to the
temperature sensor.
14. Install the Airaid Premium Filter (#1) onto the
tube on the Quick Fit Panel and tighten the clamp.
Next install the weather strip (#6) on the top of the
Quick Fit Panel as shown. (Hint: Start at one end
of the Quick Fit Panel and work your way towards
the other end.)
15. Slip the #24 speed clamp (#11) over the
factory breather hose and re-connect the fac-
tory breather hose to the nipple on the Quick
Fit Panel . Squeeze the clamp to retain the
hose in place.
FILTER IDENTIFICATION
700-445 Airaid Oiled Media 701-445 Airaid SynthaMax Dry Media - Red
702-445 Airaid SynthaMax Dry Media - Black 703-445 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.