Filter identification – Airaid 300-149 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Position Airaid tube into place by connecting
hump hose to Airaid Cool Air Dam and connect the
other end of the tube to the factory throttle body
coupler. Utilize the #60 hose clamps on the hump
hose and #56 hose clamp on the factory coupler.
10. Position the Airaid Cool Air Dam in place of
the original air box lid. Snap in place.
11. Mount the Airaid Premium filter inside the Cool
Air Dam & secure with hose clamp provided. In
addition, install the weather strip hood seal on the
Cool Air Dam. (Hint: begin in a corner and work it
on toward the ends)
12. Install urethane hump hose onto the Airaid
tube and secure using a # 60 hose clamp provided.
REV.11.1.13
14. Re-connect air temperature sensor connector to
the sensor in the Airaid tube.
15. 2002 & 2003 Models Only: Use the 90° plas-
tic elbow provided, connect the factory breather
hose with the 4 ½” hose to the Airaid tube & se-
cure using the three #16 black Speed clamps.
FILTER IDENTIFICATION
700-445 Airaid Oiled Media 701-445 Airaid SynthaMax Dry Media - Red
702-445 Airaid SynthaMax Dry Media - Black 703-445 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re-
peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
16. 2004-05 Models Only: Slide the provided rub-
ber cap over the nipple at the throttle body end of
the Airaid tube.
17. 2002 & 2003 Models Only: Slip the black rub-
ber cap over the nipple on the Cool Air Dam and
secure using the #19 Speed clamp provided.
18. 2004-05 Models Only: Connect the factory
breather hose to the Airaid Cool Air Dam & se-
cure using the #24 Speed clamp provided.
19. Double check your work to be certain that all nuts,
bolts, and clamps are securely fastened.
20. Reconnect the negative battery cable.