Filter identification – Airaid 250-292 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
14. Connect the air pump breather line to the coupling
on the Filter assembly.
11. Install the Filter Assembly in the inner bumper area.
When properly installed the Filter end cap will positive-
ly engage the grommet posts on the inner frame.
12. Install the Airaid Tube assembly onto the throttle
body and lower it downward towards the Mass Air Flow
meter. Reconnect the MAF at this time.
13. Slide the coupler all the way down onto the MAF
and secure the Intake grommets onto the posts on the
radiator shroud.
Instructions Revision
Date: 01.11.13
15. Check the alignment of all the intake components
and adjust if necessary. Begin tightening the clamps
from the front of the intake and move back towards the
throttle body. Reconnect the battery.
FILTER IDENTIFICATION
860-042F Airaid Oiled Media
861-042F Airaid SynthaMax Dry Media– Red
863-042F Airaid SynthaMax Dry Media– Blue
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning
with
common
non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of air
filter and allow to soak. Then flush
filter clean from the inside out with a
garden hose and repeat steps if neces-
sary. Do not apply high pressure wa-
ter or air to clean filter. Allow filter
to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
10. Inspect the inner bumper area and verify that none
of the air box mounting grommets were retained during
disassembly.