ACTi NVR 3 Corporate - Manual (Page 66)

www.acti.com
NVR 3 Corporate System Administrator ’s Manual
66
Configure PTZ Device
PTZ devices can do panning, tilting and zooming automatically or through manipulation. The
PTZ-related applications are broadly supported by NVR 3. For example, you may control the
movements of a PTZ camera with user interface panel controls or a joystick; the device can be
programmed to execute a continuous tour or triggered by events to go to a preset position.
Once an ACTi PTZ device is added to the system, NVR 3 will use the default settings of the
device model and enable PTZ functions, so that you may immediately start PTZ operations.
If you have previously changed the
communication parameters of PTZ devices,
please make sure these parameters on NVR
side and device side match.
The list below shows PTZ devices supported by ACTi solutions and the required settings.
When you configure PTZ protocol properties for ACTi Pan/Tilt/Zoom devices, please make
sure the required settings are correct.
To start matching up the parameters, please follow the procedures below:
1. If the device is a speed dome camera or an analog camera attached to video server,
configure the parameters on physical device according to the product’s installation
instructions.
2. On the device’s (camera or video server)web configurator, configure the parameters to
match the setting on physical device, and test the PTZ operations to make sure the device
is properly set to be connected
3. In NVR Server, go to Setup page Devices tab, select the device from Camera List , and
click PTZ tab. In PTZ Protocol section, fill in the communication parameters.
ACTi Pan/Tilt/Zoom devices Vendor Protocol Baud rate Parity
Address
ID
IP Zoom Camera/ IP PTZ Camera V V V
IP Speed Dome / IP Camera
mounted on Scanner/ Analog PTZ
camera attached to Video Server
V V V V V