ACTi NVR 3 Corporate - Manual (Page 65)

www.acti.com
NVR 3 Corporate System Administrator ’s Manual
65
Configure Storage Card Settings
Certain camera models come with the internal storage feature. Via NVR interface, you can
observe the storage card’s memory status, and configure related settings.
1. Make sure the SD card is installed properly in the camera.
2. On Setup page  Devices tab, select the device form Camera List . Click “ Storage ”.
3. On Storage window, click “ Get Storage Setting ” to sync with the SD card.
4. You can enable “ Redundant Recording when Disconnected ” function to have this
SD card take over the recording service for this channel when this device is
disconnected with NVR server. The video recorded on SD card during the
disconnection period will automatically be restored back to NVR server upon the
recovery of the connection. Before you enable this function, please do the following:
(1) upgrade the camera firmware to 6.07 or later version, and then (2) format the SD
card either on camera firmware interface or on NVR interface. (3) Synchronize the
camera time and server time. You can do this by manually setting the time on either
side to match the other’s; however, it is strongly recommend that you make use of the
NTP service to make both clocks are precisely synchronized.
5. Click “ Apply ” to save the setting.