Camera status, Status icon description – ACTi NVR 3 Corporate User Manual
Page 50
NVR 3 Corporate System Administrator
’s Manual
Camera Status
To validate if you have successfully added a camera to NVR
system, simply check the
Camera List
on the left of
Setup
Cameras
tab to see if the camera name appears in the tree.
Point your mouse cursor over the camera icon will bring up an
information box containing the camera
’s
IP Address
,
HTTP
Port
,
Protocol
and camera type.
Status Icon Description
Icon
Status Description
NVR server cannot receive the video stream. This may be that a video server is
not connected with cameras, or that the streaming is blocked by the firewall
between the camera and NVR server. Please (1) ensure that the camera is
correctly connected and can output video, (2) check the firewall and port
forwarding settings.
This camera
’s settings have been modified but not saved yet. If you leave these
modifications unsaved, they will not take effect by next time the server starts.
Please go to the page where these changes were made and save the settings
NVR cannot build up connection with this camera. Please check the camera
connection settings (including IP Address, Port number, Account Name and
Password)
; or increase the “
Connection Timeout
” to allow more time for the
camera to respond.
This camera is currently connected, video is being transmitted and no recording
is proceeding.
This camera is currently connected, and video is being recorded either manually
or according to the schedule.
The recording of the period when NVR was disconnected with this camera is
now being restored to NVR server from SD Card.
The "Redundant Recording when Disconnected" setting enabled for this
camera.